Thanks to Logan74k at TheRPF.com, I’ve been alerted to the fact that the rivet arrangement is actually mirrored across both shoulders, despite the fact that the bottlecaps are only on one of them. I wonder
And then there’s the mask. Got the plugs for the gas mask hoses painted up and attached, bent a bit of thick-gauge copper wiring up and into the jaw, and I completely revamped the
I spent a bit of time tidying up the torso sections of my armor so that I could get ready to trim them. Bought moleskin tape, but I’m practicing trying to shape it around
I detached the brass hingework for now, but took the opportunity to add the gas mask hose connectors and sub-piping. That sub-piping is actually made of very thick electrical copper wire – couldn’t tell
So, Immortan Joe’s mask opens up for added drama and intimidation during one scene in the film. Today’s engineering challenge:Â Make that damn jaw open and close in a way that is durable and robust.
I decided this project was going to be something I finished for NYCC, and it is warm enough that I don’t mind dusting off my workspace again, so I’m chugging through getting the rest
I came back to this after some time off from tinkering with it and started assembling things in earnest. The helmet got another coat of primer and some light sanding so I could see
Torso armor’s underway properly now! I used a headlight polishing kit to slightly frost the PETG I had heat-formed because it needed a bit of definition behind the armor. Only scuffed up the back
Finally made forward progress on the breastplate that wasn’t super duper frustrating. So I am using PETG sheeting in 1/16″ thickness. That’s .060″ thick, for reference. I saw TheRPF.com forums user Hamsterstyle was doing his in
I spent some time poring over the reference imagery available and trying to identify some of the badges and emblems on Joe’s codpiece, and I think I nailed some of it down. Funny enough,
You've reached the end of this content!
Looks like there's nothing here!
